Pure Sine Wave Solar Power Inverter 2000 Watt / Max 4000W / 12 Volt DC + ATS + UPS + 20A IUoU Battery Charger + 20A MPPT Solar Charge Controller This Pure Sine Wave Inverter produces from 12 Volt Direct Current Voltage (DC) a Pure Alternating Current Voltage (AC). For that it needs only a 12 Volt Direct Current Voltage (DC) for example from a Battery or Generator. Integrated 20A MPPT Solar Charge Controller This device is a combination of DC to AC voltage inverter and solar charger. With the electrical energy generated by solar cells you can charge the connected batteries. solar modules can be connected up to 70V input voltage. The maximum battery charging current is 20A and always ensures full batteries when there is enough sunlight. The MPPT (Maximum Power Point Tracker) optimally utilizes the solar power of your solar panels. The most efficient operating point of the solar panels is changed by various factors such as module temperature, irradiation, module type, etc. This operating point is constantly monitored by the internal microcontroller and controlled in such a way that the most optimal performance of the solar module is given and your batteries are loaded with the respective largest current. In opposition to conventional PWM Solar Charge Controller the full potential of your solar panels can be utilized, resulting in an efficiency of at leaset 97%. Integrated 20A IUoU Battery Charger for Lead-Acid, Gel, AGM and LiFePo4 (BMS) Batteries Once 230V is applied, the connected battery will be recharged by an built in battery charger. The charging capacity is maximum 20A. If another charger is used in your system there will be no impairment. Both chargers check the condition of the battery and adjust their charging behavior. The IUoU charging process ensures that the charger automatically switches after the main charge phase into the floating status. As a result the self-discharge and premature aging of the accumulator is counteracted and the batteries can be charged permanently. Automatic detection of an external voltage source and switching between battery and grid operation If an external power source is connected, the Automatic Transfer Switch (ATS) turns the input voltage to the ouput socket on the front panel. The connected consumers are then supplied from the external power source. The built-in intelligent IUoU battery charger ensures that at the same time the battery system will be fully loaded and switches afterwards into the floating status. As soon as the external power is not available, the ATS switches back to battery operation. Because of the short switching time of only 10 milliseconds this Pure Sine Wave Inverter is suitable for Uninterruptible Power Supply (UPS).
New Condition Weight: 5,7 kg Net / 8,2 kg Gross Size: 40cm x 18cm x 13cm 2 times Output Peak Capacity for 2 seconds Earthed Output Socket USB port to charge small consumers High Efficiency (low power losses) LED Display (Inverter, Fault, etc.) Input & Output isolated Short Circuit Protection Overload Shut Down Low Voltage Shut Down Thermal Protection Polarity Protection *Newest Soft-Start Technology integrated *Microcontroller *Automatic Voltage Regulation (AVR) *Intelligent Power Management (IPM) *Intelligent Fan Control (IFC) Certificates: CE, E-Mark, RoHS, ISO 9001 3 Years Warranty *Explanation at the end of the document
Suitable Battery Cable Set Remote Control Spare Fuses User Manual (english/german)
You do not have any products in your shopping cart yet.
Products discount up to : 50%
